Set incorporating two dynamometers and an amplifier board for recording and analysing mechanical oscillations using a standard oscilloscope. The dynamometers can be fitted to 10-mm diameter stands or the SW tie bar in order to measure dynamic forces along their axes. The amplifier board converts signals from both dynamometers so that they can be recorded and also evaluates the phase differences between both oscillation signals, outputting them as a DC signal.
If the MEC amplifier board is connected to the 2 x 50 MHz USB oscilloscope (1017264), it is possible to perform detailed analysis and evaluation of measured signals using the oscilloscope software on a PC.
Dynamometers:
Maximum force: 5 N
Frequency range: 0.3–200 Hz
Connectors: 3.5-mm jack plugs
Dimensions: 52x37x26 mm
MEC amplifier board:
Input sockets: 3.5-mm jack sockets
Output sockets: BNC
Dimensions: 65x100x40 mm
Contents:
2 Dynamometers
1 MEC amplifier board
1 Power supply, 12 V AC, 700 mA
2 Cables HF
If the MEC amplifier board is connected to the 2 x 50 MHz USB oscilloscope (1017264), it is possible to perform detailed analysis and evaluation of measured signals using the oscilloscope software on a PC.
Dynamometers:
Maximum force: 5 N
Frequency range: 0.3–200 Hz
Connectors: 3.5-mm jack plugs
Dimensions: 52x37x26 mm
MEC amplifier board:
Input sockets: 3.5-mm jack sockets
Output sockets: BNC
Dimensions: 65x100x40 mm
Contents:
2 Dynamometers
1 MEC amplifier board
1 Power supply, 12 V AC, 700 mA
2 Cables HF
Properties
- 836626
- U61023-230